Angle Grinder Brackets and Flanges

This is a genuine Milwaukee replacement part, sold individually. The Milwaukee 43-34-0935 Inner Disc Flange is placed on the spindle of the hand held grinder. Its purpose is to secure the grinding wheel to the spindle and act as a support for the grinding wheel, along with the Flange Nut (44-40-0035). This part is compatible with the Milwaukee Grinders that are shown below.

This is an Original replacement part used on certain Milwaukee Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Flange is to hold the Grinding Wheel to the Spindle Shaft. Flange designed to accommodate 7/8 In. hub depressed center wheel.

The purpose of this back flange is to help securing the grinder disk to the shaft. It is an authentic item that is supplied by original equipment manufacturer for use with Milwaukee angle grinders. This durable metal back flange is sold individually, please note the blade bolt and the front flange are all sold separately.

This is an authentic Milwaukee replacement part, sourced from the original manufacturer for use with angle grinders. The special flange is used to seal the area above the inner flange and the spindle assembly. This special flange is available as an individual replacement part, please see model diagram for associative parts.

This item has been sourced from the original manufacturer to ensure a high level of quality. The metal inner flange is intended to be used with angle grinders. Theis party is used to provide spacing between the top of the grinding disc and the guard assembly. A spanner wrench may be needed to install this item. The inner flange is sold as an individual replacement part.