Chipper Shredder Caps and Lids

Genuine OEM replacement part, this item is sold individually. The purpose of the part is to cover the air filter on the outdoor products shown below. It helps keeping larger pieces of debris from coming in contact with the air filter. While providing enough clearance for air to enter the carburetor through the air filter and mixing with the fuel to make the unit run properly.

Genuine OEM replacement part, this item is sold individually. The purpose of the part is to cover the air filter on the outdoor products shown below. It helps keeping larger pieces of debris from coming in contact with the air filter. While providing enough clearance for air to enter the carburetor through the air filter and mixing with the fuel to make the unit run properly.

This spark plug boot is an authentic OEM supplied replacement part, not an aftermarket equivalent. This rubber cap helps is used to connect the spark plug to the armature-magneto. Over time rubber material can dry out and crack requiring replacement. Please note, this part is sold individually.

Genuine OEM replacement part, this item is sold individually. The Vent Cover is installed on the vent tube on the carburetors for the outdoor products listed below. After the Vent Hood is installed on the vent line, the the Fuel Tank vent is attached to the Vent Hood.

This is an authentic replacement part that has been sourced from the original manufacturer to b used with trimmers, blowers, and power pruners. The plastic cap is used to cover the fuel fill spout to prevent spills and to block contaminants from entering the fuel system. This part assembly is sold individually.

This is an OEM sourced part that is intended to be used with edgers, trimmers, pruners, blowers, hedge clippers, and water pumps from Shindaiwa and Echo. The primer cover attaches to the body of the engine's carburetor and is used to secure the primer bulb to the fuel pump. This part is priced as a single item.

This fuel tank cap connector is an authentic OEM replacement part supplied by the manufacturer. It is compatible with over 150 models of machinery such as blowers, edgers, and trimmers. This part connects the cap of the fuel tank to the fuel tank itself. It is made of plastic, and it should be replaced if it is damaged. No tools are needed to replace this part.