Hedge Trimmer Handles

This is an OEM replacement part, it is sold individually. The Throttle Trigger controls the speed of the engine of the models listed below. The throttle cable connects to the trigger, then down to the throttle lever on the carburetor. Because of its constant use the Throttle Trigger has a tendency to break or wear out.

This throttle trigger is an OEM direct from the Echo manufacturer. The poly plastic part is compatible with several edgers and trimmers. The trigger is fastened to the control handle assembly and the trigger spring, allowing the operator to manage the amount of fuel flow to the engine. This part is sold individually. For the repair, you will need a screwdriver and a pair of pliers.

Genuine Echo replacement part, this item is sold individually This is the part of the outdoor products listed below that controls the speed of the engine by pressing it or releasing it. The throttle cable connects to this part and then down to the carburetor.

Genuine Echo replacement part, this item is sold individually. This is part of the safety start system on all of the trimmers listed below. This part is installed on the top handle and has to be pressed down while pulling the starter rope in order for the engine to start.

This is available as an individual replacement part. The throttle lever lockout attaches to the spring-lever return and lockout-trigger and helps with the safety start system. It is made of plastic and may require a screwdriver when replacing this item. This is an OEM Echo part directly sourced from the manufacturer for use with edgers, trimmers, and brushcutters.

This part is supplied directly from the original equipment manufacturer. The poly throttle trigger lockout is compatible with many edgers and trimmer devices. This item is secured within the control handle, and acts as a safety in the throttle lockout mechanism. This part is sold individually. Please refer to specific manual for repair instructions. A screwdriver is often helpful in the removal and replacement.

The plastic lever attaches to the spring and the throttle trigger. This is an OEM part sourced directly from the manufacturer and used in Husqvarna and Jonsered trimmers, pole saws, edgers, and brushcutters. This is available as in individual replacement item. This lever may become broken and will need to be replaced. During replacement, a screwdriver may be needed to install this part.