Impact Driver Hardware
YOUR TRUSTED CHOICE
- Genuine Brand Name Part
- Fast Delivery
- Expert Customer Support
Popular Impact Driver Hardware
$5.95
In Stock
This external retaining ring, also known as a snap ring or circlip, is supplied by the original manufacturer for use in impact drivers. It helps to secure the collar in the front housing assembly. It should be replaced if it is lost, damaged, or no longer able to remain securely attached. To replace the retaining ring, disassemble the front housing assembly and pull out the ring. Position the new ring in its place and reassemble the housing. Each retaining ring is sold individually.
... Read more
$6.95
In Stock
This is a genuine Milwaukee replacement part, it is sold individually. The Milwaukee Belt Hook is attached to the bottom of the handle assembly on the tool model numbers shown below. Its purpose is to hook the tool to your belt when not using the tool. The Belt Kit includes the screw to attach it to the housing of the tool.
$5.95
In Stock
This is a genuine OEM sourced replacement part which is specially designed for use with Milwaukee power tools. Washers are generally utilized to provide a tight seal between connected parts, over time it may wear out and begin to fail eventually requiring a replacement. Keep in mind this high-quality hardware is made of durable metal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this item.
... Read more
$5.95
In Stock
This is a pivot pin designed for use in impact wrenches and drivers. Its purpose is to connect the hammer and the anvil, allowing the hammer to move back and forth and drive the bit into the material being worked on. The pivot pin measures approximately 0.5 inches in length and is sold individually as a genuine OEM part made of high-quality metal. Because this is a high-wear component, the pivot pin can break or malfunction over time, necessitating replacement. If you notice that the assembly feels loose or wobbly, it is advisable to inspect the condition of this pin. If it is damaged or compromised in any way, it should be replaced. To replace this pin, you will need a punch and hammer to release the old pin, as well as a set of pliers to hold the detent pin in place when installing the new pivot pin.
... Read more
$5.95
In Stock
This is an authentic Milwaukee replacement part manufactured for use with impact drivers. The special front washer helps secure the spring inside the sleeve. This washer is sold as an individual replacement part, but will also come with the gearcase assembly (part 14-30-2657) and the anvil assembly (part 42-06-2657), please see model diagram for any other associative parts.
$5.95
In Stock
This is a genuine OEM sourced replacement part designed for use with nailers/staplers. It allows you to secure your tool to your belt for easy access. It is made out of metal and it is sold individually. Please note the screw used to secure it to the housing is sold separately.
$5.95
In Stock
$5.95
In Stock
$9.95
In Stock
This is a replacement collet nut that is specially designed for Milwaukee rotary tools. It is an authentic OEM sourced item, it is not an aftermarket imitation. This collet nut allows user to secure the collet. Please note, this metal item is sold individually.