Saw Hardware

This is a genuine OEM sourced replacement part designed for use with Milwaukee sawzall reciprocating saws. This shoe pin secures the shoe retainer. It is made of metal and it is sold individually. To complete this repair you would need a screwdriver and pliers.

This is a washer designed for use within various models of circular saws. This is a flat washer that is used within the gear case assembly to secure the shoe assembly, the part that guides the saw and prevents digging, to the saw. This washer serves multiple different purposes on the saw, so it can be used in a variety of different applications.

Genuine Milwaukee replacement part, this item is sold individually. The Pulley Hub Washer is installed inside of the Blade Pulley Cover. It is a spacer to keep the Pulley Cover and Pulley tight in place when they are fastened together.

This screw is a genuine OEM sourced hardware, it is not an aftermarket imitation. It is specially produced for Milwaukee circular saws. It is used to secure the saw blade. This hex socket head screw is sold individually. To install or remove this screw you would either need a wrench or a hex key also known as an allen wrench.

This is a genuine OEM part. The carriage bolt (m6 X 28mm) is made for use with Cordless M18 Fuel Circular Saws. The bolt secures the bevel adjustment knob on the foot, allowing the operator to cut at the preferred angle. A wrench is necessary for the repair. The metal carriage bolt is sold individually.

This item has been sourced from the original manufacturer and is intended to be used with portable band saws from Milwaukee. The kit includes the bearings, washers, and bolts that are used to mount the guide block bracket and to keep the blade in the correct position to stay on track. This kit is priced as a single item.

This genuine manufacturer-sourced screw is made for Milwaukee band saws. The screw is utilized to secure the pulley. Check the diagrams for your specific model to ensure the exact location and use of this part. It is an identical replacement for a missing or a damaged hardware that was installed on a new unit. One durable screw pulley is included. A screwdriver will be needed to secure or remove it.

This is a genuine Milwaukee replacement part and is sold individually. Its purpose along with the 06-75-2402 Blade Clamp Screw, is to clamp the blade to the reciprocating spindle of the Milwaukee Sawzall model numbers shown below. If the blade clamp is being replaced, it advisable to replace the blade clamp screw at the same time as they are both wear parts.

This is a Genuine OEM approved replacement part designed for use with Milwaukee Circular Saws. It is used to secure the Balde. This part is made out of Metal and it is Sold Individually. Requires a Hex Key or a Wrench to tighten/loosen this Screw.