Snapper Leaf Blower / Vacuum Parts
YOUR TRUSTED CHOICE
- Genuine Brand Name Part
- Fast Delivery
- Expert Customer Support
Popular Snapper Leaf Blower / Vacuum Parts
$8.35
In Stock
This Genuine OEM fuel filter is designed to maintain the performance and longevity of your equipment by preventing dirt and debris from entering the carburetor. Located inside the fuel tank, this essential component ensures clean fuel delivery, protecting the engine from potential damage caused by contaminants. Sold individually, the filter is built to meet original equipment standards for fit and function. Over time, the filter may become clogged, restricting fuel flow and making engine starts more difficult. For optimal performance, it should be replaced—not cleaned—at the first sign of blockage or wear.
... Read more
Fixes these symptoms
- Engine stops after a few seconds or minutes
- Will Not Start
$6.25
In Stock
This is an authentic OEM sourced replacement piston ring used on gas Trimmers and blowers. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase, causing low compression and a loss of power. If compression is reduced significantly, the engine will not run at all. This part is made out of metal and is sold individually. To complete this repair you will need a set of wrenches, pliers and a screwdriver.
... Read more
$6.25
In Stock
This is a genuine OEM sourced replacement part used with Poulan hedge trimmers. A spark plug delivers electric current from an ignition system to an internal combustion engine. After time spark plugs will become dirty or fouled. It is a good idea to replace the spark plug once this happens. This item is sold individually. You should gap your spark plug according to the owners manual of the outdoor product you have. You would need a spark plug wrench or a socket wrench to install this component.
... Read more
$5.95
Special Order
$6.25
Special Order
This handle is an authentic replacement part sourced and approved by the original equipment manufacturer. It is compatible with a variety of gas trimmers. This handle is attached to the end of the starter rope. By pulling the handle, the starter rope rotates the clutch assembly and starts the engine. This handle is made of plastic and sold individually.
$6.25
On Order
This is an original part from Craftsman for use with Leaf Blowers / Vacuums, Trimmers, and Hedge Trimmers. The seal crankcase prevents oil leaks between the crankshaft and crankcase opening. The most common reason for replacing the seal crankshaft is if there is leakage on the crankshaft, leakage from the crankcase, the oil seals are worn or damaged, the bearings are grinding or bearing seizures. This part is sold individually. Here is a list of tools that are needed to replace the seal crankcase is a receptacle for draining fuel, Torx wrenches, spark plug wrench or socket, a 10mm wrench (or adjustable), long-nosed pliers, rubber mallet, standard screwdriver, starter rope (or similar), adjustable pliers, socket set, 2-cycle engine oil (for lubricating seals), razor blade (to scrape gasket surface), and an ignition gapping gauge.
... Read more
$37.75
In Stock
This is a genuine OEM approved replacement part designed for use with Hitachi nailers. The piston is a central component of an engine. It both provides compression within the engine, as well as transfers the energy from combustion to the crankshaft (which creates rotation). This assembly includes the metal piston, ring, two retainers and the pin. Replacing the piston assembly is not the simplest repair, but it is definitely something you can do yourself. You will need a screwdriver to remove the cover and a set of sockets and wrenches for the rest of the repair.
... Read more
$18.85
Special Order