Trimmer Blades

This edger blade is an OEM part direct from Craftsman for edgers. This part connects to the drive shaft to edge and cut grass. It is recommended to review your models diagram to verify the parts compatibility. You will need a wrench to replace this part. This edger blade is made of metal and sold individually.

This is a genuine Weed Eater replacement part, it is sold individually. This blade is used on all of the edgers shown below. Its dimensions are 8-3/8 inches long and 1-1/2 inches wide. This blade when in use will hit concrete, rocks and other debris, which will shorten the blade. It is advised to keep one blade on hand.

This is a genuine manufacturer sourced replacement part. It is specially designed for use with Shindaiwa and Echo trimmers/edgers. These blades are perfect for edging level ground around sidewalks and driveways. Includes two (2) metal blades per order. To replace it you would need a wrench to remove the blade nut.

This part is available as an individual replacement. The upper plate adapter attaches to the circlip and the washer. It is made out of metal and will need to be replaced if it breaks. When replacing this part a screwdriver may be needed. It is a genuine OEM sourced part which is specially designed for use with Echo trimmers and brushcutters.

An authentic OEM supplied replacement part that is designed for use with Husqvarna handheld string trimmers. This line cutter blade is secured to the grass shield to cut the excess line. Over time it may get damaged or dull eventually requiring replacement. It is made from high quality steel and it is sold individually, please note the screw to secure it is sold separately.

This is an authentic replacement part manufactured for use with trimmers. The special plate adapter is used to house the oil seal, and lower bearing on in the gear case. This adapter has a slotted arbor that aligns with the grooves on the gear shaft, the adapter is sold individually.

This is a genuine Echo replacement part that has been sourced from the manufacturer to be used with hedge trimmers. The durable metal blade is used to replace the original that may have been broken or damaged. A hex driver set is needed to install the blade. This item is sold individually, please note two blades may be required.